====== NEJE R6 Rotary Lightburn Guidelines ======

[[https://neje.shop/blogs/laser-engraver/how-to-use-rotary-axis-6-with-neje-max-4|How to use rotary with NEJE Max 4 V2]]

[[https://wiki.neje99.com/en/manual/rotary|Rotary Set-up]]

=== Max 4 v2, Max 4 ===

Step1. Directly connect the** rotary drive** and **motherboard 5pin expansion interface** through a 5pin signal cable. (A Axis Port)

Step2. Measure the** diameter** of an object and fix it on a rotary.

Step3. Place the rotary directly below the X-axis after homing. Do the framing first to determine location 

Step4. Edit——Machine Settings——A Steps per mm($103): **44.444**——Write——OK

Step5. Activate the rotary.（Ctrl+Shift+R）

Laser Tools——Rotary Setup

Rotary Type: “Chuck”

“Enable Rotary” set ON

“Rotary Axis” set “**A Axis**”

If your object diameter is 100mm,then insert 100.


===NEJE 5, NEJE 5 Plus ===

Step1. Directly connect the** rotary drive** and **motherboard 5pin expansion interface** through a 5pin signal cable. (Z Axis Port)

Step2. Measure the** diameter** of an object and fix it on a rotary.

Step3. Place the rotary directly below the X-axis after homing. Do the framing first to determine location 

Step4. Activate the rotary.（Ctrl+Shift+R）

Laser Tools——Rotary Setup

Rotary Type: “Chuck”

“Enable Rotary” set ON

“Rotary Axis” set “**Z Axis**”

If your object diameter is 100mm,then insert 100.

Step5. Edit——Machine Settings——Z Steps per mm($103): **xxx**——Write——OK

**Note:** Z steps per mm ($102)=16000➗circumference=xxx

If your object diameter is 100mm,then insert 50.929(16000➗314.159)

{{https://nejetool.oss-us-west-1.aliyuncs.com/wiki/NEJE_R6_V1_manul.pdf}}