Step1. Directly connect the rotary drive and motherboard 5pin expansion interface through a 5pin signal cable. (A Axis Port)
Step2. Measure the diameter of an object and fix it on a rotary.
Step3. Place the rotary directly below the X-axis after homing. Do the framing first to determine location
Step4. Edit——Machine Settings——A Steps per mm($103): 44.444——Write——OK
Step5. Activate the rotary.（Ctrl+Shift+R）
Laser Tools——Rotary Setup
Rotary Type: “Chuck”
“Enable Rotary” set ON
“Rotary Axis” set “A Axis”
If your object diameter is 100mm,then insert 100.
Step1. Directly connect the rotary drive and motherboard 5pin expansion interface through a 5pin signal cable. (Z Axis Port)
Step2. Measure the diameter of an object and fix it on a rotary.
Step3. Place the rotary directly below the X-axis after homing. Do the framing first to determine location
Step4. Activate the rotary.（Ctrl+Shift+R）
Laser Tools——Rotary Setup
Rotary Type: “Chuck”
“Enable Rotary” set ON
“Rotary Axis” set “Z Axis”
If your object diameter is 100mm,then insert 100.
Step5. Edit——Machine Settings——Z Steps per mm($103): xxx——Write——OK
Note: Z steps per mm ($102)=16000➗circumference=xxx
If your object diameter is 100mm,then insert 50.929(16000➗314.159)