主要应用：切割，金属雕刻，绘图深度雕刻等
接口规格：4pin PH2.0（红：12V，黑：GND，黄：PWM，绿：温度信号）
波长：450nm
散热器尺寸：30*80mm
材质：铜+铝
重量：202g
驱动位置:内置
功率是否可调：可以PWM调节功率
驱动保护功能：浪涌保护，过压保护
输入功率：大约12V2A（不包含风扇功率）
线长：300mm
控制线安装方式：可插式
风扇尺寸：30*10mm
风扇转速：15000转
可控温度：小于60摄氏度
聚焦范围：5-50mm
最佳焦距：距离出光口10mm
安全警告：请在做好安全防护的前提下应用此模组！
推荐应用机器：NEJE Master
注意：NEJE Master标配12V2A充电器，如果您是希望升级旧款机器，需要另外准备一个12V3A电源
包装清单：
 1 x 模组
 2 x 螺丝
 2 x 垫片
 1 x 控制线
 

——————————–

Main applications: cutting, metal engraving, drawing depth engraving, etc.
Interface specification: 4pin PH2.0 (red: 12V, black: GND, yellow: PWM, green: temperature signal)
Wavelength: 450nm
Radiator size: 30*80mm
Material: copper + aluminum
Weight: 202g
Drive position: built-in
Is the power adjustable: PWM can be adjusted
Drive protection: surge protection, overvoltage protection
Input power: approx. 12V2A (without fan power)
Line length: 300mm
Control line installation method: pluggable
Fan size: 30*10mm
Fan speed: 15000 rpm
Controllable temperature: less than 60 degrees Celsius
Focus range: 5-50mm
Best focal length: 10mm from the light exit
Safety Warning: Please apply this module under the premise of safety protection!
Recommended application machine: NEJE Master
Note: NEJE Master comes standard with 12V2A charger. If you want to upgrade your 
old machine, you need to prepare another 12V3A power supply.
packing list:
1 x module
2 x screw
2 x gasket
1 x control line