This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. ====== NEJE R6 Rotary Lightburn Guidelines ====== === Max 4 v2, Max 4 === Step1. Directly connect the** rotary drive** and **motherboard 5pin expansion interface** through a 5pin signal cable. Step2. Measure the** diameter** of an object and fix it on a rotary. Step3. Place the rotary directly below the X-axis after homing. Do the framing first to determine location Step4. Edit——Machine Settings——A Steps per mm($103): **44.444**——Write——OK Step5. Activate the rotary.（Ctrl+Shift+R） Laser Tools——Rotary Setup Rotary Type: “Chuck” “Enable Rotary” set ON “Rotary Axis” set “A Axis” If your object diameter is 100mm,then insert 100. {{https://nejetool.oss-us-west-1.aliyuncs.com/wiki/NEJE_R6_V1_manul.pdf}} Show page