NEJE R6 Rotary Lightburn Guidelines

Max 4 v2, Max 4

Step1. Directly connect the rotary drive and motherboard 5pin expansion interface through a 5pin signal cable.

Step2. Measure the diameter of an object and fix it on a rotary.

Step3. Place the rotary directly below the X-axis after homing. Do the framing first to determine location

Step4. Edit——Machine Settings——A Steps per mm($103): 44.444——Write——OK

Step5. Activate the rotary.(Ctrl+Shift+R)

Laser Tools——Rotary Setup

Rotary Type: “Chuck”

“Enable Rotary” set ON

“Rotary Axis” set “A Axis”

If your object diameter is 100mm,then insert 100.

NEJE_R6_V1_manul.pdf

  • Show pagesource